![]() So to assign zone 7 to keypad 1, you would enter: In section 020, the first two digits will be the zone number for the keypad in slot 1 the next two digits will be the zone on keypad 2, etc. Once your keypad is assigned to a slot, you can set up the keypad zone. If you have more than one 5500, one of them should be assigned to slot 8. To assign a keypad to slot 2, enter 12 instead of 11 (13 for slot 3, 14 for slot 4, etc.). To assign a keypad to slot 1, go to THAT keypad and enter:īe careful to enter those digits precisely, or you may end up with a keypad that appears to be unresponsive (see “Why Is My Keypad Dead?” ). To avoid confusion, we will assume that you are using only one partition on your system (you can't have zero partitions). If you have more than one keypad of the same type (two or more 5500's or two or more non-5500's) then you will need to manually assign them to different slots. This assignment takes place as soon as you power up it is automatic. If you have only one keypad, then it is already assigned by default 5500 keypads are assigned to slot 8, while all others are assigned to slot 1. In order to use a keypad zone, the keypad must be assigned to its own slot (address). With two keypads, you could have two additional zones, and so on. It also allows the installer to expand the system by adding a single hardwired zone, in addition to those on the main board. Its most common use is providing a zone connection close to a door, so that the door sensor can be connected directly to Z and B on the keypad, rather than running another wire to a Z and COM on the control panel. It is important to note that using this feature will leave those zones unprotected and your security alarm monitoring station will not receive alarms from those zones until the bypass is removed.The keypad zone is a feature that has been available on most DSC keypads for many years. If your system is ready to arm, the Ready indicator will be lit. If you’re using a LED keypad, the zone LED will light and the bypassed zone number will be shown on the screen.To bypass more zones, repeat steps 3 and 4. To toggle and un-bypass a zone re-enter the 3-digit zone code or press * again.If you do not know the 3-digit zone number, scroll to the desired zone using the keys and press *.Directly bypass zones by entering their 3-digit zone number and then press *.To complete this task on a DSC Power Series Neo Security There may be many reasons for doing this, such as low battery alerts, construction or maintenance in areas of your building, or to account for animals or pets. Bypassing a zone on your security system alarm panel means that your system will disregard any alarms that come from that zone once the system is armed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |